First Time Setup; Basic Operation; Channel Selection; Volume / Mute - Kogan Series 8 JU8200 User Manual

FIRST TIME SETUP

When turning the TV on for the first time, the First Time Installation screen will
appear. Use the , , , and Enter buttons to navigate the following options.
Language
Select your menu language.
Country
Select your country.
Timezone
Select your timezone.
Following this screen, press Enter to scan for DTV channels. Ensure antenna
cable is connected to the TV as shown on page 6.
You can skip the tuning sequence at any point by pressing the Menu button.

BASIC OPERATION

Selecting channels
There are two ways to select channel:
1. Using number buttons followed by the Enter button on the remote
control to select channel directly.
– To select channel 5, press: 5.
– To select channel 21, press: 2
When using the number buttons, you can directly select channels that
were either not saved during the auto tuning, or manually erased.
2. Using CH+/- buttons on the remote control or on your TV to select
channel. When you press the CH+/- buttons, the TV changes channels
in sequence. You will see all the channels that the TV has saved, but will
not see channels that were either not saved, or manually erased.
Volume adjustment and mute setup
Press VOL
+/- buttons on the remote control or the TV to adjust the volume of
the TV.
• To increase the volume, press VOL
• To decrease the volume, press VOL
Press the Mute button to toggle TV sound on and off. The mute icon will
appear in the lower-right corner of the screen. To resume sound when TV is
muted, press the Mute button again, or simply press the VOL

Input source

Press the Input button, then use the navigation buttons to cycle through the
list of input source options. Press the Enter button to confirm your selection.
Menu settings
Press Menu button to display the main menu. Use , , , buttons to
navigate and Enter to adjust settings. Press Menu to confirm settings
changes, and Exit to exit without saving. See Page 10 for settings options.

Colour buttons

In some menus and on-screen displays, the remote control's four colour
buttons ( ) can be used.
NOTE
• ♦ W hen a menu item is greyed out, it means that the item is not available or
cannot be adjusted.
• ♦ S ome items in menus may be hidden depending on modes or signal sources
used.
1 in quick succession.
+ button
- button
+ button.
9