Before Operating - Sharp Microwave Drawer SMD2489ES Operation Manual

BEFORE OPERATING

Before operating your new Microwave Drawer, make sure you
read and understand this operation manual completely.
• Before the Microwave Drawer can be used, follow these steps:
1 Plug in the Microwave Drawer.
WAVE TOUCH CLEAR
2 Touch the STOP/CLEAR pad.
3 Set clock.
TO SET THE CLOCK
1 Touch TIMER/SETTINGS pad once.
TO SET CLOCK ENTER
2 Touch number pads for correct time of day, press START/+30
SEC.
This is a 12 hour clock. If you attempt to enter an incorrect clock
time, will appear in the display. Touch the STOP/
ERROR
CLEAR pad and re-enter the time.
• If the electrical power supply to your Microwave Drawer
should be interrupted, the display will intermittently show
ENJOY YOUR MICRO-
power is reinstated. If this occurs during cooking, the program
will be erased. The time of day will also be erased. Simply touch
STOP/CLEAR pad and reset the clock for the correct time of
day.
Note:
• The Microwave Drawer can be programmed with the
drawer open except for START/+30 SEC.
STOP/CLEAR
Touch the STOP/CLEAR pad to:
1 Erase if you make a mistake during programming.
2 Cancel timer.
3 Stop the Microwave Drawer temporarily during timed
cooking.
4 Return the time of day to the display.
5 Cancel a program during cooking, touch twice for timed
cooking.
ENJOY YOUR MICRO-
will appear.
will appear.
:
The display shows
.
TIME
after the
WAVE TOUCH CLEAR
OPEN OR CLOSE MICROWAVE DRAWER
Press the OPEN/CLOSE pad on the glass touch control or wave
twice on top left side of the drawer to open the microwave. The
Easy Wave Open only works to open the microwave, not close.
The Microwave Drawer also can be closed by gently pushing
on the drawer. Do not pull the drawer by hand, except in the
case of emergency, such as a power failure. If necessary, push
or pull slowly.
EASY WAVE OPEN ON/OFF
Easy Wave Open's default setting is OFF when plugged in. The
white light on the center of the panel will illuminate once Easy
Wave Open has been activated. When Control Lock is activated,
the Easy Wave Open function is off.
To use the Easy Wave Open function, simply wave your hand
in front of the sensor twice in consecutive motions. This can be
either up and down or side to side motions.
EASY WAVE OPEN ON
• Hold Number 5 on the glass touch control for 3 seconds
display shows
EASY
EASY WAVE OPEN OFF
• Hold Number 5 on the glass touch control for 3 seconds
display shows
EASY
12
. The
.
WAVE OPEN ON
. The
.
WAVE OPEN OFF