Side Handle; Depth Stop - Westfalia ABH 18 Original Instructions Manual

 Do not leave batteries on charge for extended periods and never
store batteries on charge.
 The battery charger monitors battery temperature and voltage while
charging. Remove the battery once charging has been completed to
maximise charge cycles of the battery and not waste power.
 Batteries can become faulty over time, individual cells in the battery
can fail and the battery could short. The charger will not charge
faulty batteries. Use another battery, if possible, to check correct
functionality of the charger and purchase a replacement battery if a
faulty battery is indicated.
 Do not store Lithium-Ion battery packs in a discharged state long
term. This can damage the Lithium-Ion cells. For long-term storage,
store batteries in a high charge state disconnected from the tool.
 The capacity of batteries will reduce over time. After 100 charge
cycles, the battery's operation time and the maximum torque per-
formance of the tool will slightly reduce. This decline will continue
until the battery has minimal capacity after 500 charge cycles. This
is normal and not a fault with the battery pack.
Operation
IMPORTANT: Put on all safety equipment required before you operate
the rotary hammer.

Side Handle

 The auxiliary handle (1) should always be used when drilling.
 The auxiliary handle angle can be adjusted to best suit the work to
be performed.
To adjust the auxiliary handle:
1. Rotate the grip anti-clockwise. This will loosen the handle assembly.
2. Move the side handle to the required position.
3. Secure in position by rotating the grip clockwise.

Depth Stop

1. Rotate the grip anti-clockwise. This will loosen the handle assembly.
2. Move the depth stop to the required position.
3. Secure in position by rotating the grip clockwise.
Operation
32