Black & Decker Coffee Bean PRCBM5 Instruction Manual page 4

English
Intended Use
Your Black and Decker Coffee Bean Mill
has been designed for grinding coffee
beans. Do not use this appliance for any
other purpose. This appliance is intended
for indoor consumer use only.
Safety Instructions
Warning! When using mains-powered
appliances, basic safety precautions,
including the following, should always be
followed to reduce the risk of fire, electric
shock, personal injury and material
damage.
• Read all of this manual carefully before
using the appliance.
• The intended use is described in this
manual. The use of any accessory or
attachment or the performance of any
operation with this appliance other than
those recommended in this instruction
manual may present a risk of personal
injury.
• Retain this manual for future reference.
• Always route the cord carefully to avoid
a tripping hazard.
• Never operate an appliance directly
below the socket-outlet it is connected
to.
Electrical safety
This tool is double insulated;
therefore no earth wire is required.
Always check that the power supply
corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre
in order to avoid a hazard.
Grinding Beans
1. Remove the lid (1) from the bowl (2) and
add the required amount of coffee
beans. Do not exceed the maximum
capacity (marked with a line on the side
of the bowl).
2. Refit the lid (1)
3. Ensure the container lid (7) is fitted
securely onto the coffee container (8).
4. Place the bowl into position on the
motor housing (6) and rotate clockwise
until you hear a ratcheting sound.
5. Select the correct grind setting. As a
guide use a fine setting for espresso, a
medium setting for cafetierres and filter
machines and a coarse setting for
percolators. Turn the bowl (2) clockwise
to select a finer setting and anti
clockwise for a coarser setting. The
setting indicator on the housing (6)
should align with the desired grind
setting marked on the bowl (2).
6. Plug the mains cable into a suitable
power supply and switch on the main
switch (10).
7. Turn the cups quantity selector (4) to
select the grinding time and then press
the start / stop button (5) to begin
grinding.
-4-