Related Manuals for System Equine TRC-6
Summary of Contents for System Equine TRC-6
- Page 1 S y s t e m E q u i n e 1 4 3 2 1 F i f t h L i n e N a s s a g a w e y a • R o c k w o o d , O N • N 0 B 2 K 0 1 ( 8 0 0 ) 4 6 1 - 3 3 6 2 •...
- Page 2 PART # DESCRIPTION QTY 6’ QTY 8’ PART # DESCRIPTION QTY 6’ QTY 8’ TRC8-1 Tine Assembly with Points (6.5”) TRC-P3/4 3/4” x 4 1/4” Hitch Pin for Blade Angle Adjustment 2 TRC-HB Adjuster Bar TRC-P3/4 3/4” x 4 1/4” Hitch Pin for 3 Point Hitch TRC-SB Straight Bar TRC LIFT PIN Lift Arm Pin Cat I 7/8”...
- Page 3 3/8” x 1 1/2” bolts and lock nuts. Repeat process until all tines are in place. NOTE: Tines should be spaced approximately 6” apart on center for the TRC-6 and 7” for a TRC-8. Tines at spaced at 6” for TRC-6 or 7” for TRC-8 THIS FINISHED SECTION WILL BE CALLED THE TINE BAR ASSEMBLY.
- Page 4 STEP 3 STEP 3 3 POINT HITCH ASSEMBLY ATTACHING THE 3 POINT HITCH 1/2” x 4” bolt and nut See STEP 3 photo before proceeding 1” spacers 1. First fasten the straight bar to the A-frame with a 1/2"x 1 1/2" bolt & lock nut FIG 3A.
- Page 5 STEP 5 STEP 5 TINE HEIGHT ADJUSTMENT ATTACHING THE TINE HEIGHT ADJUSTMENT BAR Tine height adjustment bracket See STEP 5 photo before proceeding 1. Locate the tine height adjustment bar and fasten to the center support of the tine bar assembly using the 1/2” x 1 1/2” bolt & lock nut STEP 5 photo.
- Page 6 OPTIONAL PULL-BEHIND ATTACHMENT ASSEMBLY STEP 8 (Optional Pull-behind Model Only) PULL-BEHIND HITCH PARTS ASSEMBLY OF THE PULL-BEHIND TOW HITCH See STEP 8 photo before proceeding 1. The first step with the help of an assistant, is to remove the nuts and lock washers from the lift pins where the S-shaped hitch brackets attach to the A-frame.
- Page 7 OPTIONAL PULL-BEHIND ATTACHMENT ASSEMBLY (CONTINUED) STEP 9 PULL-BEHIND WHEEL ASSEMBLY (Optional Pull-behind Model Only) ASSEMBLY AND MOUNTING OF WHEEL ASSEMBLY See STEP 9 photo before proceeding Blade height adjustment handle The final step is to assemble and mount the wheel assembly. Mount the wheels on the axles with grease nipples to the outside and tighten the nuts.
Need help?
Do you have a question about the TRC-6 and is the answer not in the manual?
Questions and answers