Samsung DW80R9950 Series Installation Manual page 27

STEP 10 Securing
1. Check the parts on the sink to which the drain hose will be connected.
2. There are several ways to insert the drain hose into the drain hose connector of the
sink, as shown in the following figures. You must connect the drain hose in accordance
with the water pipe installation regulations in your region.
Figure 8
Case 1. Without disposal
Without disposal
Case 2. With disposal
With disposal
3. Check the size of the sink's drain hose connector. If needed, cut the drain hose so its
end fits onto the sink connector (⅝ in. or 1 in. - as shown in Figure 9 below). If the end
of the drain hose does not fit onto the drain hose connector of the sink, use an adaptor
purchasable at a plumbing/hardware supply store.
DW9900R_DD68-00208B-00_EN.indd 27
Air gap
Hose clamp
With an air gap/without disposal
Air gap
Hose clamp
Disposal with an air gap
Drain
hose
Hose clamp
Without an air gap
Drain
hose
Hose clamp
Without an air gap
English 27
12/29/2018 1:57:45 PM