Installation And Connection - Bartscher 700.082G Instruction Manual

WARNING! Hazard via electrical current!
Avoid contact between the device and water. Do not allow the water to be affected
by rain, dripping water or other forms of moisture. This may lead to damage to the
device or electric shock.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the
device.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
Do not place the device in the vicinity of open sources of fire, electric cookers,
furnaces or other sources of heat such as e.g., in places exposed to direct sunlight.
The heat can damage the surface of the device, as well as have a negative effect on
the cooling power and increase the consumption of energy.
•
To avoid damage to the compressor, do not tilt the device to an angle greater than 45°
during setup or transport. Be careful when touching the condenser and doors, as
damage to them will negatively impact the working of the device.
•
2 front height-adjustable legs set so as to ensure stability.
•
Place the device in such a manner that there is a minimum of 10 cm between it and
other objects, including walls, in order to ensure proper air circulation.
•
Do not place the device where humidity or temperature are high as the device may
be damaged.
•
Do not drill holes in the device nor mount other objects to it.
•
Do not store any heavy, poisonous or rusting objects.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
- 25 -