Table of Contents
Advertisement
A
FTER UNPACKING THE APPLIANCE
not been damaged during transport and that the
appliance door closes properly.
I
, contact the dealer or the
N THE EVENT OF PROBLEMS
nearest After-sales Service.
T
, only remove the appliance
O PREVENT ANY DAMAGE
from its polystyrene foam base at the time of
installation.
MOUNTING THE APPLIANCE
F
OLLOW THE SUPPLIE D SEPARA TE MOUN TING INS TRUC TIONS
when installing the appliance.
PRIOR TO CONNECTING
on the rating plate
C
HECK THAT THE VOLTAGE
corresponds to the voltage in the home.
oven cavity is empty before
E
NSURE THE APPLIANCE
mounting.
E
NSURE THAT THE APPLIANCE IS NOT DAMAGE D
door support and that the internal door seal is
not damaged. Empty the appliance oven and
clean the interior with a soft, damp cloth.
this appliance if it has a damaged
D
O NOT OPERA TE
mains cord, if it is not working properly, or if it
has been damaged or dropped. Do not immerse
the mains cord in water. Keep the cord away
hazards may result.
AFTER CONNECTING
can be operated only if the
T
HE APPLIANCE
T
HE EAR THING OF THIS APPLIANCE IS COMPULSORY
manufacturer will accept no responsibility for
injury to persons, animals or damage to objects
arising from the non-observance of this
requirement.
INSTALLATION
, make sure that it has
. Check
. The
C
perform installation
HILDREN SHOULD NOT
operations. Keep children away during
installation of the appliance. Keep the packaging
materials (plastic bags, polystyrene parts, etc.) out
of reach of children, during and after the
installation of the appliance.
is too short or damaged it must
I
F THE POWER CABLE
be replaced. The power cable must only be
compliance with the manufacturer instruction
and current safety regulations. Contact an
authorized service center.
must be long enough for
T
HE POWER SUPPLY COR D
housing, to the main power supply.
to comply with current safety
F
OR INS TALLA TION
regulations, an omnipolar disconnect switch
with minimum contact gap of 3 mm must be
utilized.
are not liable for any
T
HE MANUFAC TURERS
problems caused by the user's failure to observe
these instructions.
EN
8
Advertisement
Table of Contents
