Turning The Machine On - Promac VAC-20PC User Manual

4.5 TURNING THE MACHINE ON

The machine is turned on/off by pressing the start/ stop
button (A).
The machine can optionally be equipped with LEDs with
power control (C). By turning the knob the suction of the
machine can be controlled. The suction performance is
also shown by the LEDs. If equipped with LED the 1
from left, when the machine is plugged in, will be ON.
To use the optional socket (B) see next chapter.
The machine can optionally be configured with an indicator (D). The indicator goes on, when the
underpressure is high. This can be due to the filter being clogged and needs to be cleaned (see later
chapter) or the bag is full and need to be replaced.
! WARNING - Do not operate without filter basket and float, as they prevent liquid from
entering the impeller and damaging the motor. Do not suck up any liquids without a sponge
filter installed.
! WARNING - To reduce the risk of back injury or falls, do not lift a vacuum cleaner heavy with
liquid or debris. Scoop or drain enough contents out to make the vacuum cleaner light
enough to lift in a comfortable manner.
NOTE: IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD LOSE SUCTION. IF THIS OCCURS, PLACE
VAC IN UPRIGHT POSITION AND TURN SWITCH OFF. THIS WILL ALLOW THE FLOAT TO RETURN TO ITS
NORMAL POSITION, AND YOU WILL BE ABLE TO CONTINUE OPERATION
! WARNING - Read the Safety Warnings and Instructions concerning the types of wet materials
that cannot be vacuumed with this product.
8
st
LED
4.6 MACHINE WITH SOCKET AND AUTO
FIG. 11
START/STOP (OPTIONAL)
The machine can optionally be equipped with
a socket that can be used in connecting with a
power tool. Connect the power tool to the
socket (A). Remove the handtube and fix the
conical adapter (B). Insert the conical adapter
to the power tool (C). Turn the machine to
AUTO mode with the switch (D). The machine
will then start, when the power tool is turned
on and stop with a delay (in order to empty the
hose) when the power tool is turned off.
FIG. 10
.
ENGLISH