Safety Instructions - Conrad Electronic ME-42 Operating Instructions Manual

Safety information
Damage resulting from non-observance of this manual renders void
any claim under the guarantee! We accept no responsibility for
consequential damage.
We accept no responsibility for damage to property or injury to per-
sons caused by improper operation or failure to obsen/e the safety
instructions. Such cases void the guarantee.
This unit is constructed and tested in accordance with DIN 57
l
411 part IA/DE 0411 part I, safety precautions for electronic
measuring devices or IEC 1010-I and left the factory in sound,
technically-safe condition. To maintain this condition and to en-
sure safe operation, it is essential for the user to observe the sa-
fety instructions and warning notes which are contained in these
operating instructions. The following symbols should be ob-
served:
. . : . : . ; j : . : . : : : . : : ; : : : : . , - : : . . : : .
. : : . : . > =Read the operating instructions
.
CAT II =Overvoltage category II
• l
Current measurements may only be carried out in circuits which I Y
l
are themselves fused at 16 A or in which no voltage greater than
250 VDCNACrms or powers greater than 4000 VA can arise. The
measuring instrument must not be used in installations of Over-
voltage Category III in accordance with IEC 664. The measuring
instrument and instrument leads are not protected against arcing
(IEC 101 o-2-031, Section 13 I Of .I 01).
Measuring instruments and accessories are not toys and do not
l
belong in the hands of children!
Dangerous voltages! Danger to life!
39