Advertisement
Quick Links
MAGNETIC_Deluxe_5RT YSH
In order to fully explore available functions of MAGNETIC DELUXE YSH series please take a moment and read this manual before using the device.
MAGNETIC DELUXE YSH transmitters are compatible with all YOODA SMART HOME brand devices.
MAGNETIC Deluxe YSH transmitters are dedicated to two-way communication.
1. General information
5-channel MAGNETIC Deluxe YSH remote control with display
and timer (MAGNETIC Deluxe_5RT YSH)
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
2. Detailed description
days of week
work mode
hour
selected channel
low battery
message
minutes
UP
DOWN
CHANNEL - (P1 -) button
5-channel transmitter with timer
(front)
1. Control:
can control single motor, or a group
of up to 20 motors on each channel
2. Range:
200 meters outdoor,
35 meters indoor
3. Battery:
CR2450
4.Power supply:
3 V
5. Dimensions:
130 x 45 x 10 mm
6. Transmitting power:
10 mW
7. Operating temperature:
from 0°C to 50°C
8. Protection degree:
IP 30
LCD display
UP button
STOP button
DOWN button
CHANNEL + (P1 +) button
programming button
work mode
1
P2
button
5-channel transmitter with timer
(back)
time change
button
Advertisement
Related Manuals for YOODA MAGNETIC DELUXE YSH Series
Summary of Contents for YOODA MAGNETIC DELUXE YSH Series
- Page 1 MAGNETIC_Deluxe_5RT YSH In order to fully explore available functions of MAGNETIC DELUXE YSH series please take a moment and read this manual before using the device. MAGNETIC DELUXE YSH transmitters are compatible with all YOODA SMART HOME brand devices. MAGNETIC Deluxe YSH transmitters are dedicated to two-way communication.
- Page 2 1.To control all receivers by the transmitter run the channel group. The group channel is on when all channels are highlighted. 2. For devices that are programmed on all channels operate at the programmed time, you should select a group channel on the transmitter and set the automatic mode.
- Page 3 6. Setting automatic time of closing and opening 1. Closing and opening time change is possible only in automatic mode. 2. The automatic closing and opening time should be set separately on each channel. 3. Longer than 60 seconds pause between successive presses of the button will automatically exit the change mode. 4.
- Page 4 4. Programming first transmitter to EV/S-type motors 1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please follow instruction of the device that is going to be controlled by the transmitter. 2. Longer than 6 seconds pause between series of button clicks during programming will cause device to switch off from programming mode without saving any changes.