Section 1
Introduction
1.4.3
6
•
Abbreviations and acronyms are spelled out in the glossary. The glossary also
contains definitions of important terms.
•
Push button navigation in the LHMI menu structure is presented by using the
push button icons.
To navigate between the options, use
•
Menu paths are presented in bold.
Select Main menu/Settings.
•
WHMI menu names are presented in bold.
Click Information in the WHMI menu structure.
•
LHMI messages are shown in Courier font.
To save the changes in nonvolatile memory, select Yes and press
•
Parameter names are shown in italics.
The function can be enabled and disabled with the Operation setting.
•
The ^ character in front of an input or output signal name in the function block
symbol given for a function, indicates that the user can set an own signal name in
PCM600.
•
The * character after an input or output signal name in the function block symbol
given for a function, indicates that the signal must be connected to another
function block in the application configuration to achieve a valid application
configuration.
Functions, codes and symbols
Table 1:
Functions included in the IEDs
Description
Protection
Three-phase non-directional
overcurrent protection, low stage
Three-phase non-directional
overcurrent protection, high stage
Three-phase non-directional
overcurrent protection,
instantaneous stage
Voltage dependent overcurrent
protection
Three-phase directional
overcurrent protection, low stage
Three-phase directional
overcurrent protection, high stage
Distance protection
Automatic switch-onto-fault logic
Fault locator
Autoreclosing
Non-directional earth-fault
protection, low stage
Table continues on next page
and
.
IEC 61850
IEC 60617
PHLPTOC
3I>
PHHPTOC
3I>>
PHIPTOC
3I>>>
PHPVOC
I(U)>
DPHLPDOC
3I> ->
DPHHPDOC
3I>> ->
DSTPDIS
Z<
CVRSOF
SOTF
SCEFRFLO
FLOC
DARREC
O -> I
EFLPTOC
I0>
1MRS756801 E
.
ANSI
51P-1
51P-2
50P/51P
51V
67-1
67-2
21, 21P, 21N
SOTF
21FL
79
51N-1
630 series
Commissioning Manual