Operation
Rotation Hei-TORQUE Precision: Additional
functions
Safety settings
✓ You have adjusted acceleration to the specific viscosity of the probe in use.
✓ You have set a speed limit, if required.
✓ You have set a torque limit, if required.
(See chapter "Start-up, Safety settings")
Setting the rotation time
▪
The time can be adjusted from 1 minute to 24 hours.
▪
Display of the program is accurate to the closest second.
➜ Select "Timer".
➜ Push the control knob.
➜ Set the duration of rotation while the
settings are displayed in orange.
➜ Start rotation using the slider.
✓ The clock symbol
top of the display.
✓ The scale below the set time indicates
the remaining time.
✓ Regardless of the set time, stirring
can be stopped at any time using the
slider.
Starting rotation via favorites
There are two ways to start a saved profile:
▪
Single operation
▪
Continuous
operation
is displayed at the
▪ The profile runs once on the basis of the set time.
▪ Rotation stops automatically as soon as the program is
finished.
▪ The profile icon is displayed at the top of the display.
▪ The profile runs until the end of the cycle.
▪ Once the cycle is finished, it starts again.
▪ The stirrer continues running until the profile is stopped
manually.
29
Remaining time
Set time
Timer