Spectracom SecureSync User Reference Manual page 521

Note:
set correctly, especially if other input references are enabled. Failure to configure
the Timescale of the input correctly could result in time jumps occurring in the Sys-
tem Time when input reference changes occur. These time jumps could affect NTP
and normal operation of the system.
Baud Rate : Determines the speed that the output port will operate at.
Data Bits : Defines the number of Data Bits for the output port.
Parity : Configures the parity checking of the output port.
Stop Bits : Defines the number of Stop Bits for the output.
Event Broadcast Output: Status Window
To view the current settings of the Event Broadcast Output , go to its Status window. For instruc-
tions, see: "Viewing Input/Output Configuration Settings" on page 347.
The Web UI list entry for this card is: Event Broadcast .
Note:
puts start at 1, because of the built-in outputs).
The Status window displays the following settings:
Signature Control : Signature Control controls when messages will be broadcast in
response to events on the Event Input (J2) port when events are enabled and the card is
in "broadcast" mode. (Events are still queued even if they are not broadcast, and are
transmitted once the signature control conditions permit.) For more information on
SecureSync User Reference Guide
The Timescale of the input (as configured in the ASCII time source) must be
SecureSync starts numbering I/O ports with 0 (only 1PPS and 10 MHz out-
APPENDIX
505