Table of Contents
Advertisement
Quick Links
C12 User Manual
GNSS Network Connected Base / Rover
This manual is for use with C12 GNSS receivers
sold by iGage Mapping Corporation.
Receivers purchased from other sources that appear to be
similar will not match devices provisioned by iGage.
26 January 2019
C12_UserGuide_BD990_R004.docx
1
C12 User Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for iGage C12
Summary of Contents for iGage C12
- Page 1 C12 User Manual GNSS Network Connected Base / Rover This manual is for use with C12 GNSS receivers sold by iGage Mapping Corporation. Receivers purchased from other sources that appear to be similar will not match devices provisioned by iGage.
-
Page 2: Table Of Contents
Table of Contents C12 User Manual GNSS Network Connected Base / Rover ........... 1 Copyright, Control and Safety ..................3 GNSS Safety Warning ............................3 Export Controlled Device ..........................3 FCC Compliance ..............................3 Thank you! ........................ 4 Overview ................................4 Product Features ............................ -
Page 3: Copyright, Control And Safety
FCC Compliance FCC Notice: C12 receivers comply with the limits for a Class B digital device, pursuant to the Part 15 of the FCC rules when it is used in the Portable Mode. Operation is subject to the following two conditions:... -
Page 4: Thank You
Your input is extremely valuable and we will listen to your suggestions! Overview The C12 Network GNSS Reciever uses a Trimble BD990 OEM GNSS board. It can be used in a variety of applications and is compatible with various platforms as a Base or Rover. -
Page 5: Accuracy
(-16 to 185 °F) Electrical Data Operating Voltage: 12V /1A Device and Part List The following items are included with the C12P9 receiver package: C12 Rover / Base Station Power Adaptor (Input 110-220V AC; output 12V DC) C12 User Manual... -
Page 6: Provisioning The C12P9
The C12P9 warranty does not cover damage caused by lightning strikes or stray welding currents. WARNING: You must disconnect the antenna cable from the C12 prior to welding on or near the GNSS antenna or mounting structure. -
Page 7: Connection Using C12P9 Serial Port
The ‘User Manual’ contains detailed configuration information for setting the C12 as a base or a rover. See section 6 for the ‘Quick Setup Guides’ to get started. Typically you will need to set the C12 Ethernet settings to match your network. Use Trimble the WinFlash utility to set the device Ethernet parameters.
Need help?
Do you have a question about the C12 and is the answer not in the manual?
Questions and answers