Table of Contents
Advertisement
6. STONE TOP INSTALLATION
STONE TOP INSTALLATION (not applicable to all models)
1. Carefully and evenly lay stone top on even surface, top-side down. Always have two
people handle the stone top when moving. WARNING: Uneven handling may cause the
stone to snap. Apply a small amount of clear acrylic adhesive caulking around the topside of
the lavatory rim near the edge. Carefully flip and lower the sink onto the stone top, align, and
press firmly. See Figure 1 to the right.
2. Attach four undermount clips and wingnuts to hold the lavatory in place as shown in the
Figure 2 to the right. Tighten wingnuts to secure the lavatory.
Wingnut
Undermount Clip
Figure 1
Figure 2
7
3. Allow for caulking drying/curing time. See caulking instructions for details.
4. Carefully flip stone stop and lavatory over and secure top to cabinet by using adhesive
caulking as shown in Figure 3 to the right. Always have two people handle the stone top
when moving. WARNING: Uneven handling may cause the stone to snap.
5. Affix backsplash with more caulking, if applicable.
Figure 3
Adhesive caulking
8
Advertisement
Table of Contents
