Table of Contents
Advertisement
Introduction
The Becker HPP-5 series positioner
represents a breakthrough in valve con-
trol technology for the natural gas in-
dustry. Built to exacting specifications,
the easily maintained unit offers highly
accurate control with excellent control
characteristics in a broad range of oper-
ating environments. The HPP-5 series
positioner is designed such that upon
reaching a valve position and achieving
a steady state, the gas consumption is
very low.
Additionally, its bleed gas
can be routed to a lower pressure
downstream or fuel gas system, elimi-
nating bleed gas completely. This
means significant savings to your com-
pany in terms of minimizing expensive
bleed gas as well as a cost saving
means of minimizing the environmental
impact of atmospheric hydrocarbons
and diminishing natural resources.
Description
The Becker HPP-5 positioner is used in
control valve assemblies with a control-
ler or I/P transducer and double acting
actuator to provide accurate flow or
pressure control. The HPP-5 can be
used with various valve types that utilize
a double acting pneumatic piston ac-
tuator.
The HPP-5 design positioner
represents Becker's commitment to
continuos development of new products
and updating of existing products to
maximize their performance while re-
taining simple operation and minimum
maintenance.
Valves over 16" in diameter require the
use of a Becker HPP-4 positioner with
Volume boosters.
HPP-5
Scope of Manual
This manual provides information on in-
stallation, operation, adjustment, and
maintenance of the Becker HPP-5 po-
sitioner. For information concerning ac-
tuators, valves, and accessories, refer
to the instruction manuals provided with
the specific product.
Note: Only those qualified through training or
experience should install, operate, or maintain
Becker positioners. If there are any questions
concerning these instructions, contact your
Becker sales representative, sales office, or
manufacturer before proceeding.
Technical Assistance
Should you have any questions, you
may contact your local Becker Preci-
sion sales representative or Becker
Precision technical assistance at:
Becker Precision Equipment, Inc.
Attn: Technical Assistance
950 Pratt Boulevard
Elk Grove Village, IL 60007 USA
Toll Free: (800) 323-8844
Tel: (847) 437-5940
Fax: (847) 437-2549
e-mail: becker@bpe950.com
2
HPP-4 Positioner
Instruction Manual
September 1999
Advertisement
Table of Contents
