Download
Share
Print this page
  1. Manuals
  2. Brands
  3. AC Air Technology Manuals
  4. Adapter
  5. AC TRACKTECH T1X2
  6. Instruction manual

AC Air Technology T1X2 Instruction Manual

Ski adapter
Hide thumbs Also See for T1X2:

Advertisement

Quick Links

Download this manual See also: Instruction Manual
MODEL: T1X2 Ski Adapter
Instruction Manual
09610 Rev. A
World's First Portable, Remote-Control Aircraft Tugs

Advertisement

loading

Related Manuals for AC Air Technology T1X2

Summary of Contents for AC Air Technology T1X2

  • Page 1 MODEL: T1X2 Ski Adapter Instruction Manual 09610 Rev. A World’s First Portable, Remote-Control Aircraft Tugs...

  • Page 2: Table Of Contents

    Contents 1. Components and Required Tools 2. Installation Guide 2-1. Initial Setup 2-2. Installing the Ski Adapter 2-3. Loading 2-4. Unloading 2-5. Warranty...

  • Page 3: Components And Required Tools

    1. Components and Required Tools Grab Plate End Cap Outside Tube Mounting Plate Inside Tube Mouting Plate Spacer Cradle Screw Mounting Plate Screw Lock Pin Grab Plate Screw Required Tools: 3/16” Hex Drive 7/32” Hex Drive 5/32” Hex Drive...

  • Page 4: Installation Guide

    2. Installation Guide 2-1. Initial Setup 1. Remove the dovetail spacers, adjustment pins, and spacer plate. 2. Remove the 2 cradle link adjustment pins. Adjustment Pin Dovetail Spacer Spacer Plate 2 Cradle Link Adjustement Pins...
  • Page 5 2. Installation Guide 2-1. Initial Setup 3. Manually unlatch the wheel cradle using the manual latch lever and set the cradle in the “down” position. 4. Using a 5/32” hex drive, loosen the 4 cradle back end adjustment screws and pull the back end “up”...
  • Page 6 2. Installation Guide 2-1. Initial Setup 6. Using a 5/32” hex drive, remove 2 cradle front end adjustment screws and set the front end to its highest “up” position. 7. Tighten the 2 cradle front end adjustment screws. Cradle Front End in Highest Position 2 Cradle Front End Adjustement Screws...

  • Page 7: Installing The Ski Adapter

    2. Installation Guide 2-2. Installing the Ski Adapter Note: Initial setup needs to be performed one time Note: Initial setup needs to be performed one time before following these steps. before following these steps. 1. Manually unlatch the cradle using the manual latch lever (It will make it easier to install the ski adapter).
  • Page 8 2. Installation Guide 2-2. Installing the Ski Adapter 4. With the wheel cradle in the “down” position use a 5/32” hex drive to loosen 4 cradle back end adjustement screws and push the back end “down” to the lowest position. 5.

  • Page 9: Loading

    2. Installation Guide 2-3. Loading 1. Remove the Ski Adapter front ends by removing 2 lock pins. 2. Using a 7/32” hex drive, remove the 2 back end grab plate screws and position the back end grab plates in the highest position as shown below. 3.
  • Page 10 2. Installation Guide 2-3. Loading 5. Position the tug so that the ski adapter is centered on the aircraft ski. Aircraft Tire Ski Adapter Aircraft Ski 6. The aircraft ski should sit above the ski adapter as you drive the tug under the aircraft ski. Please note that the aircraft can only be loaded in one direction with the front of the aircraft facing towards the front of the tug.
  • Page 11 2. Installation Guide 2-3. Loading 7. Continue to drive the tug underneath the aircraft ski until the cradle locks in the “up” position and is fully engaged onto the cradle latch. The aircraft ski should sit under the grab plate. *LOAD WITH CAUTION* Check that the top of the grab plate will clear your aircraft...
  • Page 12 2. Installation Guide 2-3. Loading 8. Install the Ski Adapter front ends and lock pins to secure the aircraft ski in place. Ski Adapter Front Ends 9. Adjust the 4 grab plates and tighten the 4 grab plate screws. Leave space between the grab plates and aircraft ski for easy removal while unloading (next section).

  • Page 13: Unloading

    2. Installation Guide 2-4. Unloading 1. Remove the Ski Adapter front ends by removing 2 lock pins. Lock Pin Front Ends Lock Pin 2. Apply slight pressure to the back end of the ski adapter by pushing the tug in the direction shown below.

  • Page 14: Warranty

    In no event shall the liability of AC Air Technology exceed the individual price of the product on which liability is asserted. AC Air Technology has no control of the set up, ap- plication, use, modifi cation, or misuse of this product, thus no liability shall be assumed or ac- cepted for any resulting damage or injury.