Connect Bluetooth Controller; Charge - Geneinno T1 User Manual

Connect Bluetooth controller

1. Connecting：
A: Start up: push the left switch to on, press the Home button (about 2 seconds) to LED1 and
LED2 to blink, and start the handle.
B: Handle connection: after starting up, the working lamp flashes and the handle enters the
connection mode. Open the right menu of APP homepage - bluetooth handle,
Click to search the bluetooth handle, and you will find the handle address and name (geneinno-
xxxx). Click to connect. Led1/2 handle will always be on after successful connection.
C. Power off: push the left switch to off and turn off the handle. 3 minutes after starting up,
the bluetooth device is not connected, and the handle is off automatically. There is no operation
for 5 minutes after the bluetooth connection of the handle, and the handle is off automatically
D. Bluetooth handle connection status confirmation:
After successful connection of bluetooth handle, open GeneROV APP and enter the full-screen
control interface of APP. The handle icon will appear in the status bar at the top of APP
L：Record
L2：Shot
Direction
control
Stick:
up/down
left/right

Charge

1. The machine battery info will be seen at APP operation interface, battery signal light info will
be seen at wireless relay; Please charge the drone when battery is low using standard charger
and plug; charge the drone for 3 hours, wireless relay for 2 hours; signal lights on charger is red
when it's charging, turn into green when fully charged.
2. Be sure, that there are no water in the plugs,before you start charging.
①
Drone
Copyright © 2018-2020 GENEINNO All Rights Reserved.
Charge
Charger
②
Wireless
relay
R：reduce LED lightness
R2：increase LED lightness
Dive up/down
X：increase gear
Y：reduce gear
A：Confirm
B：Quit
① How to charge the machine: tighten
the plug between charger and the drone
②How to charge wireless relay:
tighten the plug between charger and
wireless relay
5