SoundCraft D-Mix 500 User Manual page 18

Connections
Gnd/Screen
1. Screen
3. Cold
(signal -ve)
2. Hot
(signal +ve)
Balanced
Output
2.10
Phono Plugs
The phono plug inputs are all unbalanced.
The phono inputs are as follows:
CD1 Left, CD1 Right, CD2 Left CD2 Right, CD3 Left, CD3 Right CD4 Left, CD4
Signal
Right, Vinyl1 Left, Vinyl1 Right, Vinyl2 Left, Vinyl2 Right, Vinyl3 Left, Vinyl3
Right,Input C Left, Input C Right, Monitor Left and Monitor Right.
The vinyl inputs have RIAA equalisers for turntables.
Outputs
XLRs
The left and right main outputs are on 3-pole male XLR connectors, wired as shown
on the left. They are balanced outputs, allowing long cable runs to balanced amplifiers
or other equipment. If the amplifier (or other equipment) which you are using has an
unbalanced input, you should wire the output from the D-MIX500 as shown in the
'Balanced To Unbalanced' diagram below.
Balanced Output
Mains Earth
Balanced Output
Mains Earth
Balanced To Balanced
Signal +
D-MIX 500
Screen Signal -
Chassis Earth
Balanced To Unbalanced
Signal +
D-MIX 500
Screen
Signal -
Experience has shown that sometimes it is better
Chassis Earth
not to connect screen at external device end
External Device
Input
Screen not connected
at external device end
Input
External Device
Input
D-MIX500 Installation