Outdoors RV Mountain Series Owner's Manual page 110

Maintenance
Windows, Doors, Vents and Locks
Keep all moving parts, hinges, and latches adjusted and maintained. Pay particular attention to
emergency egress window latching. It is critical that emergency egress windows function freely in the
event of an emergency. Lubricate with light oil at least once a year. Check all component attachment
screws occasionally to ensure that none have backed off. Tighten as necessary being careful not to over-
tighten as plastic parts may crack and screws may strip out.
Window frames have weep holes along their bottom edges and must be kept clear of debris and dirt.
Condensation on the inside of a window must have a place to drain to the outside of the RV. If these
weep holes become blocked you may experience water overflowing the window track and onto the wall
and floor under high humidity conditions. Window screens may be removed and gently washed with
mild soap and water. Rinse thoroughly. Window tracks must be kept clean for windows to slide freely
and may be vacuumed with a small attachment. Additionally a small amount of silicone spray in the
tracks will typically free up most stubborn sliding windowpanes.
Lubricate locksets in doors and exterior storage compartments at least annually with powdered graphite.
If the RV is frequently exposed to salt air, lubrication may become necessary more often.
Roof vent mechanisms should also be lubricated using a graphite powder. These can be accessed either
from the roof (with the vent lid open) or from the inside with the screen removed.
Sealant Renewal of Exterior Components
This section outlines the procedures you must follow to maintain the weatherproof integrity of your RV.
Leak damage caused by failure to inspect and maintain the roof, vents, TV/Radio antenna and molding
seals may affect your warranty coverage.
The adhesives and sealants used in the construction of your RV were developed to remain waterproof
under sustained effects of weather and vibration. However, even the finest materials will eventually dry
out and lose their effectiveness. If your sealants are intact with no voids or cracking or peeling, resealing
is not required.
Your dealer can perform the resealing inspection and work for you if you choose. Your dealer also has
current information on sealants used in your RV and can recommend the appropriate sealants for you if
you prefer to do the work yourself. Always use sealants recommended by your dealer or Outdoors RV.
Remember that any work performed by your dealer creates documentation that may be required for
potential warranty work in the future.
Resealing Exterior Components
Inspect the sealants around all exterior components, doors, windows, corner moldings, etc. at least every
three months. If any visible shrinkage, cracking or peeling, or any voids or missing sealant is evident
these areas must be resealed immediately.
Remove any loose or peeling sealants. Wipe clean all areas to be resealed with an isopropyl alcohol
using a clean dry rag. Allow to dry before applying new sealant.
106