ION 1807T-ME Owner's Manual page 8

ASSEMBLY INSTRUCTIONS CONTINUED
We strongly recommend using two people to ease of the treadmill assembly.
For your convenience, there is a tool kit included with the treadmill.
NOTE
: Make sure that the power cord is unplugged before you begin installation.
1. Use the guide wire pre installed in the
right side upright (D) to secure the main
control wire harness.
2. Next feed the cable through the opening
as shown and pull the guide wire from
the top of the upright (D).
3. Next insert the rubber sleeve in the
bottom opening on the right side upright
(D) as shown.
4. Place both uprights (C,D) onto the frame
base as shown in arrows, then secure
them with 4 bolts (a) on each side with
the allen wrench provided.
BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
7
www.ebladez.com