Sony Cyber-Shot DSC-S600 Modifiers Manual page 6

Route the wires
Put the shutter board back into the plastic housing
and screw the housing back to the camera. Twist
the wires into a small cable and route the cable
around the LCD display as shown in Figure 5.
Secure the cable to the bottom with some tape.
From here you can drill a hole in the bottom of the
case and export the cable there, or add a 2.5mm
female connector inside of the tri pod port, or even
add a 3-wire servo connector. We leave this up to
the person who does the modification since this is
a personal preference.
Figure 5
Re-attach case and replace the screws
Once you are complete with this process place
the camera case back together and replace the
camera case screws.
Attaching the Sony S40 to the PixController LE
Board and Universal Board
1. Wiring your S40 camera to the PixController
LE board.
Connect the following wires to your LE board:
Shutter – Shutter on LE, J2-1
Ground – Ground on LE, J2-2
Power – Refresh on LE, J2-3
Last, remove the R17 resistor from the LE board,
see: http://www.pixcontroller.com/PixLE
/PixLE_ResistorRemoval.htm
PixController LE Camera Port Diagram