Sony Cyber-Shot DSC-S600 Modifiers Manual page 4

Adding some tape...
Before you go any further you need to add some
masking tape or scotch tape as shown in Figure 1
and Figure 2.
In Figure you 1 need to add some tape to hold the
LCD screen in place during the camera
modifications. If you do not add this the LCD will fall
out and can be damaged.
In Figure 2 you need to add the tape here to mask
off the flash contact points. If you do not add this
tape and touch these contact points you will be
shocked.
Be sure to remove this tape when closing the
case back up after your modification is finished.
Remove the shutter board screw
Next remove the shutter board screw as shown and
carefully lift the shutter board and plastic housing
from the camera.
Figure 1
Figure 2