Porsche CDR-31 2011 Driver Manual page 35

Note
If the CDR-31 display shows the message "Error
during authorisation process" then the process
may have timed out or a different code may have
been entered in the mobile telephone. Repeat the
procedure in this case.
If the authorisation still fails, then external authori-
sation should be used. Please refer to Section
"EXTERNAL AUTHORISATION" on page 33.
Symbols in the status bar (symbols seen de-
pend on the mobile telephone used)
Mobile telephone connected
(signal strength displayed)
Mobile telephone connected
(signal strength not displayed)
No mobile telephone connected
Connecting an authorised mobile
telephone
The CDR-31 will detect when a previously author-
ised mobile telephone is in range and will send a
connection request to the mobile telephone. If sev-
eral authorised mobile telephones are in range,
then the CDR-31 will connect with the most recent-
ly connected mobile telephone. If it is not possible
to connect to this mobile telephone, then the pre-
viously connected mobile telephone will be
searched for.
f Accept the connection request on the mobile
telephone. Follow the prompts displayed on
the mobile telephone (refer to the instruction
manual for the mobile telephone).
Note
With certain mobile phones the connection re-
quest has to be confirmed by the CDR-31 on the
mobile telephone. This may even have to be done
several times, e.g. before transferring the phone-
book . To avoid these prompts you can authorise
the CDR-31 in the device list on your mobile
phone. On your next attempts the connection will
be established automatically without query. Please
refer to the mobile telephone instruction manual
for further information.
External authorisation
If the CDR-31 cannot find your mobile telephone,
or the authorisation process repeatedly fails when
initiated by the CDR-31, then the authorisation can
be initiated from the mobile telephone.
1. If another mobile telephone is connected to the
CDR-31, switch off Bluetooth
mobile telephone in order to close the connec-
tion with the CDR-31.
2. Press the PHONE button.
3. Press the OPTION button or tap "OPTION" on the
touchscreen.
4. Select "Device list".
The CDR-31 is now visible to external devices.
5. Use the mobile telephone to search for devic-
®
es that support Bluetooth
(refer to the in-
struction manual for the mobile telephone).
6. Send a connection request from the mobile tel-
ephone (refer to the instruction manual for the
mobile telephone).
®
7. Enter any Bluetooth
code on the mobile tele-
phone (e.g. "1234") and confirm .
A connection request will appear on the
CDR-31.
8. Select "Yes" to accept the connection request.
Telephone mode (optional)
®
on the other
33