Advertisement
Intel and AMD steps after installing the pump / CPU WB
A.
Install radiator and fan (intake provides the best performance).
Connect fan and pump to the motherboard's 3- or 4- pin fan
headers; please check your motherboard's manual for the
location of its fan headers, as connecting this to an incorrect
jack can potentially cause irreparable damage to components.
It is recommended to enter your motherboard BIOS and set
the fan header connected to the CLC to 100%.
Otherwise you may get a WB not detected error in your OS.
B.
Install the USB cable to enable PWM-tuning via software.
Connect the cable from the CPU pump to the USB 2.0 front
panel header on the motherboard.
The CPU Water Block software can be downloaded at the link
below:
http://www.evga.com/support/download/
Important Information
EVGA CPU Closed Loop Water Cooling Kit is an AIO (All-In-One) cooling system. With AIO Water Cooling
Systems, you do not need to add any coolant, and the system is completely self-contained. All EVGA CPU
Closed Loop Water Cooling Kits are leak tested at the factory, and are ready to install when received.
Warranty for the EVGA CPU Closed Loop Water Cooling Kit
Your EVGA CPU Closed Loop Water Cooling Kit comes with a 5 (five) year warranty. Refer to your motherboard's
warranty information before installing the EVGA CPU Closed Loop Water Cooling Kit. Should you damage
your motherboard during the installation process, EVGA will not be held liable for the physical damage of
your EVGA CPU Closed Loop Water Cooling Kit, case, motherboard or any associated hardware when damage
is caused by improper installation.
E009-00-000276
Advertisement
