Emerson Fisher 846 Instruction Manual page 12

Type 846 and Model 3311
ADDITIONAL ADAPTER PLATE
PART NUMBER 03311-0318-0001
REQUIRED FOR I/P WITH
STAINLESS STEEL HOUSING
U BOLT
5/16-18 x 5/8 BOLTS
ADAPTER PLATE
(SEE DETAIL "B")
NOTES:
THE MOUNTING POSITIONS SHOWN ALLOW ANY MOISUTRE BUILDUP IN THE TERMINAL COMPARTMENT
1
TO DRAIN TO THE SIGNAL WIRE CONDUIT ENTRANCE. DO NOT MOUNT THE TRANSDUCER WITH THE TERMINAL
COMPARTMENT COVER ON THE BOTTOM; MOISTURE MAY ACCUMULATE IN THE TERMINAL COMPARTMENT
OR PILOT STAGE, PREVENTING PROPER TRANSDUCER OPERATION. THE VERTICAL MOUNT IS MOST EFFECTIVE
FOR MOISTURE DRAINAGE IN WET APPLICATIONS.
2
IF MOUNTED ON HORIZONTAL PIPE, THE I/P MUST BE ON TOP OF THE PIPE FOR PROPER MOISTURE DRAINAGE.
3 THIS DIMENSION IS 44 (1.74) FOR STAINLESS STEEL HOUSING.
14B7332
19B9484-B
E0786 / IL
2–4
MOUNTING BRACKET
(SEE DETAIL "A")
FOR PROPER
MOISTURE
DRAINAGE,
THIS END
MUST BE UP
41
3
(1.61)
VERTICAL MOUNT
2-INCH PIPESTAND MOUNTING
5/16-18 x 3/4 BOLTS
(4 PLACES)
32
(1.25)
WALL/PANEL MOUNTING
Figure 2-3. Typical Transducer Mounting with Universal Mounting Bracket
2
1
MOUNTING BRACKET
(SEE DETAIL "A")
5/16-18 HEX NUT (4 PLACES)
ADAPTER PLATE
(SEE DETAIL "B")
MOUNTING BRACKET (SEE DETAIL "A")
FOR PROPER
MOISTURE
DRAINAGE,
THIS END
MUST BE UP
Instruction Manual
February 2002
FOR PROPER MOISTURE
DRAINAGE, THE I/P
MUST BE MOUNTED ON
TOP OF THE PIPE
ADDITIONAL ADAPTER
PLATE PART NUMBER
03311-0318-0001
REQUIRED FOR I/P
WITH STAINLESS STEEL
HOUSING
5/16-18 x 3/4 BOLTS (4 PLACES)
HORIZONTAL MOUNT
1
Form 5739
1
mm
(INCH)