Waterous Aquis 2.5 SSP Installation & Operation Instructions page 2

Waterous, Arizona Operations
Warnings, Cautions, and Notes
Warning: A warning alerts you to a procedure, practice or condition that may result in death or long
term injury to personnel or destruction of equipment.
Caution:
Note: A note points out important information. Failure to read the note may not result in
Revision History
Revision Date Issued
- 11/03/09
1 7/22/10
2 8/6/10
3 5/9/11
Disclaimer:
These instructions are guidelines only and in no way meant to be definitive. During installation, standard safety
precautions and equipment should be used where appropriate. Because the tools used and the skill/experience of
the installer can vary widely, it is impossible to anticipate all conditions under which this installation is made, or to
provide cautions for all possible hazards. Proper installation is the responsibility of the purchaser. All bolts,
setscrews, and belts must be checked prior to start-up AND after the initial operation. Damages due to poor
installation are the responsibility of the installer.
Waterous reserves the right to make modifications to the system without notice
Aquis 2.5 SSP Installation & Operation
A caution alerts you to a procedure or condition that may result in serious
damage to equipment or its failure to operate as expected
physical harm to personnel or equipment. It may waste time and money.
Comments
Initial Release
Added F5, F6 to the Calibration section & priming
mode (in operations), updated fig 5 & fig 6
Added Foam Cert
Added Pump Maintenance
Added Flow Tee drawing
Page 2 of 30
Rev 3