Advertisement
HOW TO USE REMOTE
1. POWER ON/OFF
1.
Open the snap latch
and take out the remote
2. START TO RIDE
Trigger switch must keep pressing while riding,
once you release the trigger, motor will stop.
3. WHEN YOU START OR ONCE YOU RELEASE THE TRIGGER
The dial throttle must go back to minimum position, then hold the trigger switch.
4. TURBO MODE
Turbo button makes take off much easier for beginners.
The e-foil board needs enough speed and power to leave water; therefore, the mode of remote
should be in the maximum. After leaving the water, speed will decrease then you have to step back.
Just pressing the Turbo button and the speed will increase 20%,
releasing the button will return. You don't need to adjust the speed by down and up.
It makes easier to leaving the water !
NOTE:
IF THE REMOTE CAN NOT CONNECT WITH THE BOARD ,PLEASE FOLLOW THE STEPS AS BELLOW :
1. Turn off the board's power and remote
2. Turn on the board's power.
3. Press & hold remote's power button while OFF, until OLED shows "PAIRING..."
4. When the remote shakes and OLED shows
2.
Press & hold 3sec.
until OLED turn on
, it means paired
3.
Turn on the board.
When the remote shakes and
on the OLED screen, that means remote and
board are connected
Dial the throttle button to adjust speed.
shows
Advertisement
