H3C S5500-SI Series Operation Manual page 8

Operation Manual – QinQ-BPDU TUNNEL
H3C S5500-SI Series Ethernet Switches
III. Configuration procedure
Note:
With this configuration, the user must allow the QinQ packets to pass between the
devices of the service providers.
1) Configuration on Provider A
# Enter system view.
<ProviderA> system-view
Configuration on GigabitEthernet 1/0/1
# Configure GigabitEthernet 1/0/1 as a Hybrid port that permits frames of VLAN 1000
and VLAN 2000 to pass, and configure the port to remove the outer tag of the fames
when sending them out.
[ProviderA] interface GigabitEthernet 1/0/1
[ProviderA-GigabitEthernet1/0/1] port link-type hybrid
[ProviderA-GigabitEthernet1/0/1] port hybrid vlan 1000 2000 untagged
# Configure the port to tag frames from VLAN 10 with an outer tag with the VLAN ID of
1000.
[ProviderA-GigabitEthernet1/0/1] qinq vid 1000
[ProviderA-GigabitEthernet1/0/1-vid-1000] raw-vlan-id inbound 10
[ProviderA-GigabitEthernet1/0/1-vid-1000] quit
# Configure the port to tag frames from VLAN 20 with an outer tag with the VLAN ID of
2000.
[ProviderA-GigabitEthernet1/0/1] qinq vid 2000
[ProviderA-GigabitEthernet1/0/1-vid-2000] raw-vlan-id inbound 20
[ProviderA-GigabitEthernet1/0/1-vid-2000] quit
[ProviderA-GigabitEthernet1/0/1] quit
Configuration on GigabitEthernet 1/0/2
# Configure VLAN 1000 as the default VLAN of the port.
[ProviderA] interface GigabitEthernet 1/0/2
[ProviderA-GigabitEthernet1/0/2] port access vlan 1000
# Enable basic QinQ so that the port tags frames from VLAN 10 with an outer tag with
the VLAN ID of 1000.
[ProviderA-GigabitEthernet1/0/2] qinq enable
[ProviderA-GigabitEthernet1/0/2] quit
Configuration on GigabitEthernet 1/0/3.
1-7
Chapter 1 QinQ Configuration