JVC KD-LHX501 Service Manual page 8

3.1.3 Removing the top chassis assembly
(See Figs.3 to 6)
• Prior to performing the following procedures, remove the heat
sink.
Reference:
Remove the front panel assembly as required.
(1) From the bottom side of the main body, remove the two
screws C attaching the top chassis assembly to the bottom
chassis assembly. (See Fig.3.)
(2) From the both and rear sides of the main body, remove the
five screws D attaching the top chassis assembly to the
bottom chassis assembly. (See Figs.4 to 6.)
(3) Lift the top chassis assembly in the direction of the arrow,
disconnect the connector
trol board from the connector
(See Figs.5 and 6.)
(4) Take out the top chassis assembly from the bottom chassis
assembly.
1-8 (No.MA045)
CN501 on the mechanism con-
CN721 on the main board.
Bottom chassis assembly
C
Top chassis assembly
Fig.3
Top chassis assembly
Bottom chassis assembly
Fig.4
Mechanism control board
Top chassis assembly
Main board
Bottom chassis assembly
Fig.5
D
Bottom chassis assembly
Fig.6
C
D
CN501
D
CN721
Top chassis assembly
D
D
Rear bracket