General Handling - BAQ kaloMAX Manual

BAQ kaloMAX

3 General handling

Power switch / fuses
The power switch and the fuses ( 2 x T 1 A ) are located at the back side of the
unit between power connector and power switch.
Specimen holder
The samples are clamped into a small vice. The upper part of the vice jaws can
be turned to fit round or straight samples. This parts can be replaced in case of
damage.
Compound table
The specimen holder is mounted to a compound table with a movement range
of 25 x 25 mm.
Movable stand
The adjustment to different ball diameters or sample thickness is done by
moving the whole unit of specimen holder and compound table. To move the
unit, the fixing screws at the back side have to be loosened.
LED readouts
The LED readouts show the actual values for the number of revolutions (rpm),
the grinding period and the selected program.
After power up, the last parameters are active.
When the motor is started, the remaining grinding time will be displayed
continually.
Buttons
The 'START'-button starts the grinding procedure using the active parameter for
revolutions and grinding period.
The 'STOP'-button stops the grinding. The motor stops immediately.
The 'ENTER'-button is used to set up a new program.
By means of the ↑↓ buttons beneath the readouts for revolutions and grinding
period, the corresponding values can be changed stepwise.
When any parameter is changed, the program number is set to '-'. A test run can
be done by pressing the start button.
Manual
Page 5