Advertisement
4.3.
QUICK START CHART refer to fig.3
4.4.
Switch on the tester by connecting the clamps to the battery.
4.4.1.
choose an option from the menu:
4.5.
START_STOP BATTERY TEST
4.5.1.
Press the ◄ ► key to select START-STOP Test.
4.5.2.
In this stage, there are 3 tests for selection.
START-STOP TEST
bATTERY TEST
SYSTEm TEST
4.5.3.
Press the ◄ ► key to select battery type:
a. EFb (ENHANcED FlOODED)
b. AGm FlAT PlATE
Press «ENTER» to confirm choice.
4.5.4.
Press the ◄ ► key to select battery rating:
SAE (ccA), EN, IEc or DIN. Press «ENTER»
to confirm choice.
4.5.5.
Press the ◄ ► key to input the battery capacity:
SAE (ccA): 40~2,000
EN: 40~2,100
DIN: 25~1,300
IEc: 30~1,500
Press «ENTER» to begin test.
4.5.6.
Press the ◄ ► key to confirm the position of the battery if
the surface charge is detected.
Follow the tester's steps to remove the surface charge if it
happens.
4.5.7.
Testing battery.
4.5.8.
When test is completed, the display shows the results as following
{Press the◄ ► key to select: SOH (STATE OF HEALTH) or
SOc (STATE OF cHARGE)}.
GOOD & PASS
The battery is good and capable of holding a charge.
© Jack Sealey limited
START-STOP
TEST
bATTERY TYPE
EFb
SElEcT RATING
SET cAPAcITY
XXXX SAE
TEST IN VEHIclE?
TESTING
GOOD & PASS
XX.XXV
XXXXSAE
Original Language Version
Fig.3
SAE
NO
bT2014 | Issue:1 01/06/17
Advertisement
