Configuring Bpdu Tunnel - H3C S5500-SI Series Operation Manual

Operation Manual – QinQ-BPDU TUNNEL
H3C S5500-SI Series Ethernet Switches

2.2.2 Configuring BPDU Tunnel

Perform the following tasks to configure BPDU tunnel:
Enter system view
Enable BPDU tunnel
globally
Enter
Ethernet
port view
or port
group
view
Enable BPDU tunnel
for the Ethernet port
Disable STP for the
Ethernet port
Enable
tunnel for the Ethernet
port
To do... Use the command...
system-view
bpdu-tunnel
enable
Enter
interface
Ethernet
interface-number
port view
port-group
Enter port
port-group-name
group view
aggregation agg-id }
bpdu-tunnel
enable
stp disable
STP BPDU
bpdu-tunnel dot1q stp
Chapter 2 BPDU Tunnel Configuration
—
Optional
Enabled by default
dot1q
BPDU tunnel is available to
a port only when it is
enabled globally.
Use either command
interface-type
Configuration performed in
Ethernet port view applies to
the
{ manual
Configuration performed in
|
port group view applies to all
the ports in the port group.
Required
Disabled by default
When
dot1q
enabled, BPDUs of the
service provider network are
isolated from those of the
customer networks.
Required
Enabled by default
Before enabling STP BDPU
tunnel for an Ethernet port,
you need to disable STP for
the port.
Required
By
command on the port with
BPDU tunnel enabled, STP
BPDU tunnel is enabled for
the port.
2-3
Remarks
current port only.
BPDU tunnel is
configuring this