Sony SLV-SE80EN/EG Operating Instructions Manual page 15

5
PROGRAM
Press PROGRAM +/– (repeatedly) to select the appropriate TV
system for your area. Select "G" for the B/G TV system, or "K" for
the D/K TV system.
6
Tune the TV to the same channel as that
shown in the display window so that
the picture on the right appears clearly
on the TV screen.
Refer to your TV manual for tuning
instructions.
If you select the wrong TV system in
step 5, the picture on the right may not
appear. Select the appropriate TV
system and tune the TV again.
If the picture does not appear clearly,
see "To obtain a clear picture from the
VCR" below.
7
Press RF CHANNEL.
You have now tuned your TV to the VCR. Whenever you want to
RF CHANNEL
play a tape, set the TV to the video channel.
To check to see if the TV tuning is correct
Set the TV to the video channel and press PROGRAM +/– on the VCR. If
the TV screen changes to a different programme each time you press
PROGRAM +/–, the TV tuning is correct.
To obtain a clear picture from the VCR
If the screen does not appear clearly in step 6 above, go to step 7 to finish
this procedure once. Then start again from step 2. After pressing RF
CHANNEL, press PROGRAM +/– while the RF channel is displayed, so that
another RF channel appears. Then tune the TV to the new RF channel until a
clear picture appears.
Note
• If you set the wrong TV system, you may have no sound or sound may be distorted.
SONY VIDEO CASSETTE RECORDER
Getting Started
15