Advertisement
Installation and Maintenance Instructions
You have purchased a premium quality AP Series battery to install in
your sport vehicle. In order to assure you get the best possible
performance from your battery, UPG highly recommends these
procedures:
Be certain the battery fitment you have chosen is the correct one
1
for your vehicle. If you are in doubt, ask your battery salesperson
for assistance.
NOTE: Once a conventional battery has been activated, it
cannot be returned unless it is determined to be defective.
Please be certain you have selected the correct battery for your
vehicle.
After you have performed all steps outlined for preparing your battery
2
to be installed (such as filling, full charging before installation, etc.)
please follow these steps for installation:
Examine the cavity in your vehicle where the battery is to be mounted.
3
See that all debris, rust, dirt, or other foreign matter has been cleared.
Examine the vehicle cables and connectors for rust, corrosion,
4
damaged insulation, or poor vehicle connection. Replace cables if
needed, clean and tighten cable connections to the vehicle.
Insert the battery with the terminals facing as prescribed by the
5
vehicle manufacturer. This will assure you will be connecting the
vehicle's battery cables to the correct battery terminals.
Connect the (+) POSITIVE battery cable to the (+) POSITIVE
6
terminal of the battery. Tighten the connection securely. Then
connect the (-) NEGATIVE battery cable to the (-) NEGATIVE battery
terminal. Tighten the connection securely. To test the connection,
turn on your headlight, turn signal, brake light, or any other electrical
device on the vehicle to confirm proper operation. Then start your
vehicle to be certain all functions are correct.
IF all is satisfactory, then replace the vehicle battery covers and
7
parts as they were removed.
POWERSPORTS BATTERIES
AP SERIES
4
Advertisement
