Advertisement
9
Place the empty pack in the white box
for disposal.
Install the unused portion of the long
10
tube set aside earlier onto the side
battery vent and insert the six white
filler-hole plugs firmly on the top of
the battery.
11
Check to see if there is any electrolyte visible on the battery. If so,
neutralize with baking soda, rinse with water and wipe dry.
Properly dispose of the empty plastic electrolyte pack at a
12
battery-recycling center near you.
An initial charge is recommended before placing the battery in service.
13
If the electrolyte level falls after charging then fill with distilled water
to the "UPPER LEVEL". DO NOT add more electrolyte.
Make sure the end of the long tube is past
14
all motorcycle parts and can cause no
damage. If the battery vents, some acid
could exit the bottom of the vent tube.
To maximize battery life, check your AP Series conventional battery
monthly and if electrolyte level is below the "UPPER LEVEL", refill
with distilled water.
Always dispose of used batteries in an authorized
battery recycling facility.
Enjoy!
3
Empty
Place filler plugs
back on
Vent
Tube
Vent
Tube
White
Box
Pb
Advertisement
