Dell Emc Recommended Switch Configuration; Hardware Configuration; Delete Startup Configuration - Cisco Nexus 9372PX Configuration Manual

2

Dell EMC recommended switch configuration

Use the following steps to configure the Cisco Nexus 9372PX switch.
Note: The configuration steps in this section are only recommended when the switch is used as a dedicated
SAN for iSCSI traffic (not shared with LAN traffic).
2.1

Hardware configuration

1. Power on the chassis.
2. Connect a serial cable to the active supervisor management port.
3. Using PuTTY or another terminal utility, open a serial connection session to the switch.
4. Open a terminal emulator and configure it to use the serial port (usually COM1 but this may vary
depending on your system). Configure serial communications for 9600,N,8,1 and no flow control.
2.2

Delete startup configuration

Note: This example assumes a switch at its default configuration settings. Using the write erase
command will set the startup configuration file to its default settings. Always back up the configuration
settings prior to performing any configuration changes
switch#write erase
Warning: This command will erase the startup-configuration
Do you wish to proceed anyway ? (y/n) [n]y
switch#reload
This command will reboot the system
Do you want to continue? (y/n) [n]y
Note: The switch will reboot.
6 Cisco Nexus 9372PX Switch Configuration Guide for Dell PS Series SANs | SCG3665