Advertisement
Packing List
The contents:
♦ One Main Unit
♦ One DC Power Adapter
♦ One LINE Cable
♦ One Console Cable (DB9)
♦ One CD with User Manual.
Front Panel
Front Panel of SHDSL 4-wire/4-port router/bridge
Front Panel of SHDSL 2-wire/1-port router/bridge
Figure 1: Front Panel
Rear Panel
Figure 2: Rear Panel
Install the SHDSL Router
To avoid possible damage to this Router,
do not turn on the router before Hardware
Installation.
Connect the power adapter to the port labeled DC-
IN on the rear panel of the product.
Connect the Ethernet cable.
Note: If the 1-port router is directly connected to PC or
NB, the Ethernet cable has to be used cross over one.
If the 1-port router is connected to hub or switch, be
sure that the hub or switch supporting auto-sensing. If
yes, both cross over and none cross over Ethernet
cable are suitable. If not, only pass through Ethernet
cable could be used. The 4-port router supports auto-
MDIX switching hub so both through and cross-over
Ethernet cable can be used.
Connect the phone cable to the product and the
other side of phone cable to wall jack.
Connect the power adapter to power source.
Turn on the PC or NB which is used for
configuration the Router.
Connections
:
Figure 3: Direct Connection with PC or NB for
1-port router
Figure 4: Connection with Hub/Switch for
1-port router
Figure 5: 4-port router with complex network
topology
Advertisement
