Operation - Avery Dennison SS Finisher User Manual

Operation

Theory of Operation
Safety Issues / Warnings
Warning:
Users Manual SS Finisher
The SS Finisher was designed to cut and stack pre-printed woven
polyester stock. The machine uses ultrasonic vibrations to cut and seal
the label producing a cut edge is as soft and smooth as the original label
tape. The SS Finisher will accept label tapes that were printed on a
variety of different machines.
This machine has some pinch points and hot surfaces. All of these areas
have been well guarded and it is recommended that the safety features
of this machine are never altered or defeated.
Since ultrasonic is high frequency sound, some noise will be produced as
it makes its cut. It is recommended that people in the immediate area
wear ear protection. (See appendix "A" for a list of manufacturers of
hearing protection.)

High voltage is present in the power supply. Never attempt to
operate the unit with the cover off.

To prevent the possibility of electrical shock, make sure the
power supply is properly grounded.

Keep hands from under horn. High pressure and vibrations can
cause injury to hands and fingers.

Large plastic parts may vibrate within the audible frequency
range when cutting. If this occurs, use ear protection to prevent
possible injury.

Do not allow the ultrasonically activated horn to touch a metal
base or metal fixture.

Do not press the "TEST" switch when the converter is removed
from the equipment.
Operation  7