Advertisement
MCV2000 SERIES HYDRONIC VALVE
Take care that installer is a trained experienced service
person.
When installing this product:
Read these instructions carefully.
Failure to follow them could damage the product or
cause a hazardous condition.
Check the ratings given in the instructions and on the
product to make sure it is suitable for your application.
Always conduct a through checkout after installation.
INSTALLATION
1. The valve may be plumbed in any angle but
preferably not with the actuator head below the
horizontal level of the valve body. Make sure there is
enough room around the actuator head for servicing
or replacement.
2. The valve body can be mounted directly onto the
inlet pipe. Mount the metal flange inserted in socket
to outlet pipe. And then tighten the socket enough to
make a seal. See Figure 2 for the detail dimension.
3. Mount the valve directly in the tube or pipe. Do not
grip actuator head while making and tightening
plumbing connections. Either hold valve body in your
hand or attach adjustable spanner across the
hexagonal or flat faces on the valve body.
Honeywell Co., Ltd.
Environmental Controls
18F, Kukje Center Building 191, Hangangro-2ga,
Yongsan-gu, Seoul, 140-702, Korea
Tel. 82-2-799-6170/6194
Fax. 82-2-799-6188
ENS5001R2 KO06 2005
WARNING
Disconnect Power Supply before making electrical
connections to prevent electrical shock and equipment
damage.
WIRING DIAGRAM
WHITE
(CLOSE)
SPST Controller
BLACK
(OPEN)
L
N
GREEN
Fig. 3 Diagram with 3-wire Actuator for SPST Controller
SPDT Controller
NC
NO
L
N
Fig. 4 Diagram with 3-wire Actuator for SPDT Controller
4
CAUTION
MCV2000 Series
NO
NC
RLY
MCV2000 Series
WHITE
(CLOSE)
BLACK
(OPEN)
GREEN
Advertisement
