Table of Contents
Advertisement
Stepper Demo – This brings up a specialized window that was created for testing stepper valves, but can
•
also be used to send a 0-5 analog signal to two other connected devices.
•
Advanced – This brings up the advanced window which enables the user to modify the PID settings in the
controller to get the optimal response for their system. This interface also gives technicians the ability to
send messages directly to the controller using the terminal.
Modify IP Address – This brings up an option to modify the IP Address settings for the CPC-1. The CPC-
•
1 Can be configured to have a fixed IP Address specified by the user, or the IP Address can be left open
to be set by the DHCP Network.
Update Controller Firmware – In cases where the controller's version does not match the desktop
•
software's version then a controller update may be necessary. The update controller firmware feature will
install the controller firmware that matches the software version.
17
Manual version 1.0.2
Advertisement
Table of Contents
