Table of Contents
Advertisement
3. Select the CPC-1 from the list (if the controller does not show up, then check that the controller is connected
to the correct network. See trouble shooting section for more details. Click cancel and on the controls screen
click connect to try connecting again) Note: all active comports will show up in the connections. If connecting
via serial port you may want to open the device manager to determine which com port relates to the CPC-
1
4. After you have connected to the CPC-1 then the controls window will appear, See Figure 6.
Figure 6: Controls window, showing sensor dials, alarms and process control modes.
7.2.1 Controls Window
The controls window is the main window for the smart control interface. This window shows the current readings
from the sensors, the system alarm notifications, the mode controls with set point adjuster, and the main menu.
7.2.1.1 Sensor Gauges
Each sensor gauge displays the current value for that sensor as seen by the controller. The gauge limits are set in
the setup window when specifying the analog I/O. Each gauge has a black pointer showing the current value for
that sensor, and a small gray marker, that shows what the current set point for the operation mode. Note: When
no sensor is connected, then the pointer will stay at a position about 25% of the maximum value.
15
Manual version 1.0.2
Advertisement
Table of Contents
