Table of Contents
Advertisement
Removal
Remove transaxle, clutch assembly (if equipped) and
flywheel/drive plate. Using a knife, cut off oil seal lip. Pry oil
seal from rear seal housing. Use care not to damage sealing surfaces.
Installation
1) Ensure all sealing surfaces are clean. Apply grease to
seal lip of NEW oil seal. Use Oil Seal Installer (SST 09223-63010) for
oil seal installation.
2) Install oil seal in rear seal housing until oil seal is
even with surface of rear seal housing. Apply Loctite to
flywheel/drive plate bolts. Install flywheel/drive plate. Install and
tighten bolts to specification in a crisscross pattern. See TORQUE
SPECIFICATIONS. To install remaining components, reverse removal
procedure.
WATER PUMP
Removal (Camry & Celica)
1) Disconnect negative battery cable. Drain cooling system.
Remove timing belt and idler pulleys. See TIMING BELT under REMOVAL &
INSTALLATION.
2) Disconnect lower radiator hose from thermostat housing.
Remove alternator adjusting bracket. Remove coolant by-pass pipe nuts.
See Fig. 45.
3) Remove water pump bolts in sequence. See Fig. 46. Remove
water pump, water pump cover and "O" rings. See Fig. 45. Remove water
pump-to-water pump cover bolts. Remove water pump and gasket from
water pump cover.
Fig. 45:
Exploded View Of Water Pump & Components
Courtesy of Toyota Motor Sales, U.S.A., Inc.
Hide quick links:
Advertisement
Table of Contents
