Table of Contents
Advertisement
Fig. 15:
Control Rod & Bracket Bolt Installation Sequence (Camry)
Courtesy of Toyota Motor Sales, U.S.A., Inc.
NOTE:
Remove engine and transaxle as an assembly.
Removal (Celica)
1) Release fuel pressure. See FUEL PRESSURE RELEASE under
REMOVAL & INSTALLATION. Remove hood and battery. Drain cooling system
and engine oil.
2) Remove air intake duct with air cleaner assembly and air
cleaner case. Remove relay box from bracket, located near battery.
Remove lower cover from relay box. Disconnect fusible link assembly
and other electrical connectors from relay box.
3) Remove A/C relay box from bracket, located near
passenger's side front corner of engine compartment. Remove cruise
control actuator and bracket (if equipped).
4) Remove radiator and coolant reservoir tank. Remove strut
tower-to-firewall braces. Disconnect necessary control cables,
electrical connections, fuel lines, coolant hoses and vacuum hoses.
5) Remove charcoal canister. Remove A/C compressor (if
equipped) and power steering pump with hoses attached and secure
aside. Disconnect connectors at Engine Control Module (ECM) and
remaining engine wiring connectors. See Fig. 16. Remove nuts from
firewall and pull engine wiring out through firewall.
Hide quick links:
Advertisement
Table of Contents
