Electrolux ESF6767KXA User Manual page 26

26 electrolux.com.au
TROUBLESHOOTING
If the program won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by
pressing the Power On / Off button.
• Be sure that the water inlet filter and the machine
filters are not clogged.
If detergent residues are left in the detergent
compartment
• Detergent has been added when the detergent
compartment was wet.
If water is left inside the machine at the end of
the program
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The program is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a
wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
If there are partial food wastes left on the dishes
• Dishes placed incorrectly into the machine, sprayed
water did not reach related places.
• Basket overly loaded.
• Dishes leaning against one another.
• Very small amount of detergent added.
• An unsuitable, rather weak wash program selected.
• Spray arm clogged with food wastes.
• Filters clogged.
• Filters incorrectly fitted.
• Water drain pump clogged.
(CONTINUED)
If there are whitish stains on the dishes
• A very small amount of detergent is being used.
• Rinse aid dosage setting at a very low level.
• A detergent without phosphate used; try one that
contains phosphate.
If the dishes are not dry
• A program without a dry operation selected.
• Rinse aid dosage set too low
• Dishes unloaded too soon
If there are rust stains on the dishes
• Stainless-steel quality of the dishes washed is not
dishwasher grade.
• High level of salt in the wash water.
• Poor mains grounding.
Call an Authorised Service Centre if the problem still
persists after the controls or in case of any malfunction
not described above.