Table of Contents
Advertisement
Available languages
Available languages
Installation / Bringing into use / Operation
1. Remove the wall bracket
the housing by sliding it downwards (Fig. A).
2. Mount the wall bracket
desired position on the wall with the sup-
plied screws
and dowels
7
Note: The supplied dowels are intended for
use in ordinary solid masonry. Seek expert
advice on suitable fixings if the device is to
be fixed to another type of wall construction.
3. Pull the separation strip out of the battery
compartment
.
8
4. Then mount the scale on to the wall bracket
Note: Measuring accuracy may be detri-
mentally affected if the device is not in-
stalled vertically.
©
Bringing into use
©
Setting the time
Press the MODE / + button
device enters the clock mode.
Press the SET / WEIGHT MODE button
to enter the settings mode. The minute dis-
play value flashes.
You can use the MODE / + button
Digital timer / UNIT / Alarm / - button
to set the value.
Note: If you keep these buttons
pressed, you can accelerate the process
and reach the desired value more quickly.
Press the SET / WEIGHT MODE button
to store the set value and move on to setting
the hour display value. The hour value flashes.
You can use the MODE / + button
Digital timer / UNIT / Alarm / - button
set the value.
Press the SET / WEIGHT MODE button
to store the set value and leave the settings
mode.
Note: If no key is pressed within 10 seconds,
the set value will stop flashing and the time
is set to the value shown in the display.
8
GB/IE
63925_silv_Digitale_Küchenwaage_content_LB3.indd 8
©
Operation
10
from the back of
vertically in the
The device has five functions:
10
.
1. Time display
6
2. Weighing
3. Temperature display
4. Alarm function
5. Digital countdown timer
You can switch between the various func-
.
tions by pressing the MODE / + button
10
©
Using the time display
Press the MODE / + button
vice enters the clock mode.
The display shows the time (hours:minutes).
If you wish to change the time to another
value, proceed as described in the section
5
until the
"Setting the time".
Note: The device continues to show the
time unless the device is switched to anoth-
3
er function by you pressing the MODE /
+ button
or the
5
4
©
Using the scale
,
4
5
Note: When using this product as a tabletop
unit, make sure it is placed on a solid and flat
surface for the weighing process.
3
Fold down the glass plate
or the
Place the weighing bowl
5
4
to
weighing platform.
If necessary press the MODE / + button
until the device enters the weighing mode.
3
This comes after the time display.
You can press the SET / WEIGHT MODE
button
mode settings for weight
milk
ting is indicated by a small bar indicator in
the display.
until the de-
5
.
5
9
.
on the device's
1
to switch between the weighing
3
17
, water
15
. The selected weighing mode set-
.
5
5
16
and
23.02.11 15:49
Advertisement
Chapters
Table of Contents
