Learning The Commands Of Your Components - Sony STR-DE897 Operating Instructions Manual

Learning the commands of
your components
By using the Learning function, it is possible for
this remote to perform learned commands.
Setting remote control codes
that are not stored in the remote
When a remote control code is not one of the
presets stored in the remote, it is possible for the
remote to learn the code using the Learning
function.
1
Press TV ?/1 while holding down
RM SET UP.
The indicator lights up.
2
Press the input button (including TV
?/1) for the component you want to
control.
For example, if you are going to learn an
operation for a CD player, press SA-CD/
CD.
3
Press the button you want to use for
the Learning function.
The indicator turns off while a valid button
is pressed, then flashes slowly.
4
Point the remote control code receiver
section of the remote towards the
receiver/transmitter on the remote
control to be learned.
5–10 cm
5
Press the appropriate button on the
remote control to be learned to send
the remote button code.
Lightly pressing the button once should be
sufficient.
If learning is completed successfully, the
indicator slowly flashes twice and the
remote automatically exits the learning
mode.
When learning is not completed
successfully, the indicator flashes 4 times in
quick succession and the procedure returns
to step 5.
If the memory of the remote is already full,
the indicator flashes 8 times in quick
succession and the remote automatically
exits the learning mode.
Notes
• You can program more than 80 keys for the Learning
function. In some cases, you may not be able to
program even if you have not programmed 80
buttons. The number of buttons you can program for
each input button are shown in the following table.
Input button area
VIDEO 1, VIDEO 2,
DVD
VIDEO 3, TV/SAT,
TAPE
MD/DAT, SA-CD/CD,
TUNER
PHONO, MULTI CH
TV buttons, (TV ?/1,
TV VOL +/– , TV CH +/–,
WIDE, TV/VIDEO
• In steps 2 and 3, the indicator turns off while a valid
button is pressed.
• In step 3, if several buttons that can be used for
learning are pressed, only the last pressed button is
valid. The indicator flashes slowly, it turns on while
a valid button is pressed.
• In step 5, if a button that can be used for learning is
pressed, the new button is selected and the learning
procedure returns to the beginning of step 5.
Number of Buttons
you can program
78 keys
78 keys
78 keys
52 keys
7 keys
continued
51 GB