Tuning To Preset Stations; Presetting Radio Stations - Sony STR-DE695 Operating Instructions Manual

Preset tuning (continued)

Presetting radio stations

1
Press TUNER FM/AM.
The last received station is tuned in.
2
Tune in the station that you want to
preset using Direct Tuning (page 34) or
Automatic Tuning (page 35).
3
Press MEMORY.
"MEMORY" appears in the display for a
few seconds.
Do steps 4 to 5 before "MEMORY" goes
out.
4
Press PRESET TUNING + or PRESET
TUNING – repeatedly to select a preset
station number.
Each time you press the button, the preset
station number changes in the
corresponding number and direction as
follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
If "MEMORY" goes out before you press
the preset station number, start again from
step 3.
5
Press MEMORY again to store the
station.
If "MEMORY" goes out before you can
store the station, start again from step 3.
6
Repeat steps 2 to 5 to preset another
station.
To change a preset number to
another station
Do steps 1 to 5 to preset a new station to the
number.
Tip
In Step 4, you can also use the remote to select a
preset station number. Press SHIFT repeatedly to
select a memory page (A, B or C) and then press the
numeric button to select a preset number.
GB
36

Tuning to preset stations

You can tune the preset stations by either of the
following two ways.
Scanning the preset stations
1
Press TUNER FM/AM.
The last received station is tuned in.
2
Press PRESET TUNING + or PRESET
TUNING – repeatedly to select the
preset station you want.
Each time you press the button, the receiver
tunes in one preset station at a time, in the
corresponding order and direction as
follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
Using the preset codes
Use the supplied remote to perform the
following operations. For details on the buttons
used in this section, see pages 44–51 for remote
RM-PP412 and pages 52–55 for remote
RM-U307.
1
Press TUNER on the remote.
The last received station is tuned in.
2
Press SHIFT to select a memory page
(A, B, or C), then press the preset
number of the station you want using
the numeric buttons.