Sewing Basics Winding The Lower Thread; Inserting The Bobbin - Silvercrest SNM 33 C1 Operation And Safety Notes

Getting ready
Winding the lower thread
A
B

Inserting the bobbin

1
3
A
5
12 US-EN
2
4
6
A. Place the spool (m) on the spool pin (15)
and hold it in place with a spool pin cap (r).
- Small spool pin cap for thin threads
- Large spool pin cap for thick threads
B. Or place the secondary spool pin (q) on
to the hole for the second spool pin (22).
Pull the thread from the spool into the
thread guide, and up to the bobbin thread
guide (2).
Pull the thread from the inside through a
hole of the empty bobbin (g). Place the
bobbin (g) on the bobbin winder spindle
(14) and then push to the right into the
Hold the end of the thread. Press the
pedal (t). Release the pedal (t) after a few
turns. Release the thread and cut as close
as possible to the bobbin (t). Press the
pedal (t) again.
Once the bobbin is full, it rotates more
slowly. Release the pedal (t). Replace
the bobbin (g) into sewing position and
remove it.
Note:
If the bobbin winder spindle (14) is in the
winding position, the sewing process is
automatically interrupted. To sew, push
the bobbin winder spindle (14) to the left
(sewing position).
Important:
Turn the power switch (20) to off ("O").
filling position.
When inserting or removing the bobbin (g),
the needle must be fully raised.
A
1. Open the hinged cover.
2. Pull the bobbin case tab (A) and remove
the bobbin case. Hold the bobbin case
with one hand.
3. Insert the bobbin so that the thread runs
in a clockwise direction (arrow).
4. Pull the thread into the slit and under
the tension spring.
5. Hold the bobbin case between the index
tab (A).
6. Insert it into the shuttle race.
Note :
The method of bringing up the lower
thread is explained on page 15.
finger and thumb on the bobbin case